Search found 6 matches

by Vesku
Sat Jan 09, 2010 3:06 pm
Forum: Dual VR
Topic: Weber/Marelli ignition question
Replies: 0
Views: 1630

Weber/Marelli ignition question

I´m trying to make replacing ecu for sierra cosworth, which have weber/marelli system. I get good and steady rpm in stimulator, but in car have some problems. The basic setup is like ms2 extra refer. Have tried few times, but couldn´t get engine running. I send here composite logger log from startin...
by Vesku
Sat Dec 19, 2009 7:47 am
Forum: Introduce yourself
Topic: Hi!
Replies: 1
Views: 1454

Hi!

And creetings from Finland! I have few MS1 and 2 projects. Have European 1989 ford sierra cosworth with MS1 extra, European sierra with ford 302 v8 and MS2 and ford escort MK1 -72 with cosworth engine and MS2. Now I`m going to COP and sequential injection with these 4cyl cosworth engines and asking ...
by Vesku
Sat Dec 19, 2009 3:44 am
Forum: 4-Channel Driver
Topic: Problem with sequential
Replies: 9
Views: 4631

Re: Problem with sequential

Yep! I try grounding also in this morning but still have that 26.65Hz, when should have 6.66Hz. then I connect outputs from driver to leds and all worked fine! I´m sure now, that my meter see all those 4 drivers, as You told. Think that when there was no load for drivers, ground might flow... And wh...
by Vesku
Fri Dec 18, 2009 7:01 pm
Forum: 4-Channel Driver
Topic: Problem with sequential
Replies: 9
Views: 4631

Re: Problem with sequential

I have to take a look tomorrow for all connections. I have that feeling that I have been missing something... There will come 6.66Hz/injector from connecting points with 800rpm and rpm is very stable, but after injector driver it will show 26.65Hz. I measured frequency from all incoming signal point...
by Vesku
Fri Dec 18, 2009 4:25 pm
Forum: 4-Channel Driver
Topic: Problem with sequential
Replies: 9
Views: 4631

Re: Problem with sequential

Sorry!! I was in hurry before and sen wrong msq :oops: And thanks for Your response allso!

Now there is right one.
by Vesku
Fri Dec 18, 2009 1:49 pm
Forum: 4-Channel Driver
Topic: Problem with sequential
Replies: 9
Views: 4631

Problem with sequential

Hello from Finland! I started to build full sequential injection to my car and have some problems.. Car is 4cyl european ford sierra cosworth and it´s using weber marelli ignition system. I ordered few times ago dual vr board, 4-channel driver and V2.0 prosessor for stim. I get cop working but have ...