So I will route the port 2 out of the board. Maybe I will add a jumper option to change it to port 1 for debugging purposes.
Nice! I assume all of them can be used also as on/off style outputs? In that case I will change all high current outputs to these pins so they can be used as PWM or on/off outputs as needed.jbelanger wrote: All the channels from timer 1 and 2 can be used for PWM outputs. So that allow up to 8 of them.
Could you tell more about the RTC, what chip it uses? It might be a nice addition.the I2C bus 1 (SDA1, SLC1) is used for the RTC, The I2C bus 2 is used for the SLC-OEMs.