New boards that are planned or are in development
-
jbelanger
- Posts: 3860
- Joined: Sat Oct 03, 2009 12:24 pm
- Location: Quebec, Canada
-
Contact:
Post
by jbelanger » Tue Feb 09, 2016 5:49 pm
vatnehol wrote:Hi.
I would like to order one with 2 egt inputs.
Ronny
Ronny,
PM sent.
Jean
-
shainiac
- Posts: 1
- Joined: Mon Feb 22, 2016 11:35 am
Post
by shainiac » Mon Feb 22, 2016 11:41 am
Jean,
Could you please PM me price and availability for a 4 EGT and 8 EGT card?
Thanks,
Alex
-
jbelanger
- Posts: 3860
- Joined: Sat Oct 03, 2009 12:24 pm
- Location: Quebec, Canada
-
Contact:
Post
by jbelanger » Tue Feb 23, 2016 12:16 am
Alex,
PM sent.
Jean
-
suberimakuri
- Posts: 19
- Joined: Sat Apr 19, 2014 4:45 pm
Post
by suberimakuri » Thu Jan 12, 2017 4:48 am
Hi Jean, can you please PM price for 4 and 8 channel EGT? Thank you.
-
MS2tester
- Posts: 59
- Joined: Mon Feb 23, 2015 8:04 am
-
Contact:
Post
by MS2tester » Wed Oct 03, 2018 1:59 pm
i have been reading up on the ability of the tinyOX to connect to tunerstudio or msdash through the CAN bus
or at-least displaying data from the CAN bus connected devices like MS2 or MS3
would the diyautotune CAN EGT be able to do the same?
i see a lot of questions from people who want to run a dedicated dashboard (rasberry)
and have the ability to tune with a second device
so it would be great if the CAN EGT can pass through can data to a rasberry dash
while the ms2 or ms3 is connected to a laptop or other device running tune software
-
jbelanger
- Posts: 3860
- Joined: Sat Oct 03, 2009 12:24 pm
- Location: Quebec, Canada
-
Contact:
Post
by jbelanger » Wed Oct 03, 2018 2:13 pm
Yes, the CAN-EGT can send data through the CAN bus. I'm not sure exactly which configuration you're thinking of so you would need to give more details.
Also this thread is about my own version of the CAN-EGT. If you want to discuss the DIYAutotune version, you should post on the msextra forum in the expansion boards section. That's a different device with a different firmware so it will have different settings. I will still reply there and support you as needed but you will also get more views.
Jean
-
imakehp
- Posts: 3
- Joined: Tue Sep 04, 2018 4:48 pm
Post
by imakehp » Sat Dec 01, 2018 6:02 am
I need a board for 8 TC's that will work with MS2 V3.0 CAN bus.......
Will this board do this without issues and what is the cost?
Thanks, Dave