Help CAN-EGT Firmware Update

Main site: http://jbperf.com/index.html
MS2tester
Posts: 61
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: Help CAN-EGT Firmware Update

Post by MS2tester » Thu Jul 30, 2020 12:38 am

I was using a new Windows 10 laptop that is driving me crazy with the bloatware
I had several Windows warnings of USB device not recognised
This might have happened during the firmware update
I suspect this was the issue
Should have used my trusted toshiba tecra with native rs232 port :roll:

MS2tester
Posts: 61
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: Help CAN-EGT Firmware Update

Post by MS2tester » Sun Aug 29, 2021 2:32 pm

I recently did a new raspberry install and tried to download the proper ini
AMP EFI is still on 0.1.4 firmware and ini
The Diyautotune.com site does not even have an ini
Just the firmware
Luckily i knew i could download it here
But i don't think new customers are going to be very happy with this!?
As the serial reading from the LC1 was not working with the older firmware
Maybe a dedicated sticky on the msextra forum?

jbelanger
Posts: 3870
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada
Contact:

Re: Help CAN-EGT Firmware Update

Post by jbelanger » Sun Aug 29, 2021 2:56 pm

This is a DIYAutotune product and their web site so they should be the ones making sure this is available. I have spent a long time communicating with them to get this going (as well as time to correct the code and review the updated documentation) and it seemed like they were going to do it but then nothing. If you were to email them about this, it might give them an additional push to finally update their site.

As for the msextra forum, I don't have admin privileges there so I cannot create a sticky. Again, you might be able to help with that if you post something there.

Jean
Image

MS2tester
Posts: 61
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: Help CAN-EGT Firmware Update

Post by MS2tester » Tue Aug 31, 2021 2:06 am

i will give that a try!

Post Reply