Help for a dumb noob.

Main site: http://jbperf.com/index.html

Help for a dumb noob.

Postby novaracer63 » Wed Sep 04, 2013 2:50 pm

sorry for my first post here to be asking for help but hey maybe I can help later. Everyone here seems to be very helpful.
So just build my ms3x setup using ls2 coils on a small block 350. Doing waste spark and batch before I try seq. So it fires up on 4 cylinders that I can confirm by hot header primaries. Im using a 36-1 wheel set to 80* btdc like the ms3 manual says. Plugs are wet when I pull them on the cylinders that don't fire. Ive confirmed that all my spark channels are correct with the I/O test in tuner studio. I have a good VR signal while cranking at least...not sure about when its running on 4 cylinders. Ill attach my MSQ(seems to be what people ask for right?) and a data log for my 4 seconds of glory
thanks in advance for any help.
Attachments
2013-09-04_11.04.08.msl
tune
(43.14 KiB) Downloaded 123 times
Nova MS3.msq
data log
(176.16 KiB) Downloaded 129 times
novaracer63
 
Posts: 2
Joined: Wed Sep 04, 2013 2:32 pm

Re: Help for a dumb noob.

Postby jbelanger » Wed Sep 04, 2013 3:02 pm

I don't know if you have posted this on the msextra forum (http://www.msextra.com/forums/) but your post will be seen by a lot more people there. Moreover, since this is strictly an MS3 issue that is the place to go; the forum here is to support the jbperf.com products and you don't seems to be using them.

It's not that I don't want to support and help you but the place for it in this case is on the msextra forum.

Jean
Image
jbelanger
 
Posts: 3578
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada

Re: Help for a dumb noob.

Postby novaracer63 » Wed Sep 04, 2013 3:24 pm

oh sorry thanks for the tip
novaracer63
 
Posts: 2
Joined: Wed Sep 04, 2013 2:32 pm


Return to General

Who is online

Users browsing this forum: No registered users and 1 guest