Same question of ms2

Main site: http://jbperf.com/index.html

Same question of ms2

Postby sergiosag » Thu Feb 04, 2016 5:49 pm

Hi i want to know if any have trouble with Fuel Pump output.

In my case when the FP is off i get 0V in output and when is on obteined 5V. But the problem is that 5v cant activate the relay.
Something similar happen with Idle PWM output, when i change the transistor that says in ms extra manual, but when test the port in test mode and get 5v volt on and off 0v.
In both circuits the signal out is gnd and not a 5v?
In the circuit schematic of manual says something of position jumpers in JP1. In my ms2 doughtboard the jumpers JP1 all cut this is normal?

Anyone can help me, becouse i dont understand muchos of electronic
sergiosag
 
Posts: 6
Joined: Thu Jul 23, 2015 6:52 am

Re: Same question of ms2

Postby jbelanger » Thu Feb 04, 2016 5:53 pm

Most of the MS2 outputs are grounding outputs. And this question has nothing to do with the jbperf.com products so you should post on the msextra forum.

Jean
Image
jbelanger
 
Posts: 3539
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada


Return to General

Who is online

Users browsing this forum: No registered users and 1 guest

cron