Page 1 of 1

no sync after 3 yrs of running great

PostPosted: Wed Oct 25, 2017 2:00 pm
by subarvair
my setup is a 3.3l suby run by ms3/3x. I am using Jean's internally mounted 2.0 board on the crank vr only. after 3 yrs of running great, I suddenly lost sync. On TS, I cannot get a comp log or trigger or tooth. The output of the 2.0 board is dc 1.2v powered and 2.0v cranking. On the AC scale it is 2.3v powered and 4.2v cranking. Do these figures sound normal or has the conditioning board gone bad?
Any ideas are welcome
Thanks
Mike