jim stim assembled problem

http://jbperf.com/JimStim/index.html
Post Reply
1stop74
Posts: 1
Joined: Fri Dec 20, 2019 5:04 pm

jim stim assembled problem

Post by 1stop74 » Fri Dec 20, 2019 9:05 pm

I assembled a jim stim, first timer here, and have no power led light. One side of led has power. Nothing on other side coming out. Using a 9v battery. Checked all leds with diode option on multimeter after board was assembled. Cant get any to light up. Are leds directional? If so, how to tell? I read note in instructions not to overheat ,so i was careful to not do so, but new to all of this. I have a thread in general, newbees on megasquirt forum.

jbelanger
Posts: 3755
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada
Contact:

Re: jim stim assembled problem

Post by jbelanger » Fri Dec 20, 2019 10:26 pm

I think it would be better to continue on the msextra forum since there will be a lot more traffic there so others can chime in. I have replied there.

Jean
Image

Post Reply