dumb question (dual VSS input for traction control)

[linuxman51]

With ms3 and the traction control stuff, they say to use PT4 for "high tooth" count abs sensors (mine are 44 teeth). This is fine except I'd like to run both for %slip, so this requires using another high frequency type input in addition to pt4.

The question is then, does the use of this board require the schottky diode referenced, or could one connect the output directly to the input on the ecu?

[jbelanger]

The dual VR board gives a 0-5V output signal so it can be used directly. You don't need anything before or after.

Jean

[linuxman51]

excellent, thank you Jean!