dumb question (dual VSS input for traction control)

http://jbperf.com/dual_VR/index.html

dumb question (dual VSS input for traction control)

Postby linuxman51 » Mon Oct 27, 2014 3:04 pm

With ms3 and the traction control stuff, they say to use PT4 for "high tooth" count abs sensors (mine are 44 teeth). This is fine except I'd like to run both for %slip, so this requires using another high frequency type input in addition to pt4.

The question is then, does the use of this board require the schottky diode referenced, or could one connect the output directly to the input on the ecu?
linuxman51
 
Posts: 2
Joined: Mon Oct 27, 2014 2:47 pm

Re: dumb question (dual VSS input for traction control)

Postby jbelanger » Mon Oct 27, 2014 3:59 pm

The dual VR board gives a 0-5V output signal so it can be used directly. You don't need anything before or after.

Jean
Image
jbelanger
 
Posts: 3578
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada

Re: dumb question (dual VSS input for traction control)

Postby linuxman51 » Mon Oct 27, 2014 4:09 pm

excellent, thank you Jean!
linuxman51
 
Posts: 2
Joined: Mon Oct 27, 2014 2:47 pm


Return to Dual VR

Who is online

Users browsing this forum: No registered users and 1 guest

cron