VR 2.1 board for 2002 Mustang GT

http://jbperf.com/dual_VR/index.html

VR 2.1 board for 2002 Mustang GT

Postby CalBoy101 » Fri Dec 04, 2015 11:22 pm

Hello-

I need an ABS sensor interface board for my 2002 Mustang GT.

The ABS sensors it has are 2 wire, will your VR 2.1 board work correctly with those sensors?

If you aren't sure is there a test I can do on them to confirm that they are VR sensors, I have a good voltmeter/ohmmeter.
CalBoy101
 
Posts: 2
Joined: Fri Dec 04, 2015 11:17 pm

Re: VR 2.1 board for 2002 Mustang GT

Postby jbelanger » Sat Dec 05, 2015 11:51 am

These are almost certainly VR sensors. You could always measure the resistance between the 2 wires and you should read something around 200 to 1000 Ohms.

They will very likely work with the board and there are other people using the board with ABS sensors. However, since each setup is different there is always a possibility that something may make this more difficult or even impossible to work. So there is no guarantee but, as I said, it is very likely that it will work.

Jean
Image
jbelanger
 
Posts: 3633
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada

Re: VR 2.1 board for 2002 Mustang GT

Postby CalBoy101 » Sat Dec 05, 2015 2:21 pm

Jean, thanks for your reply, it looks like they are VR sensors so I'm going order one of your boards.
CalBoy101
 
Posts: 2
Joined: Fri Dec 04, 2015 11:17 pm


Return to Dual VR

Who is online

Users browsing this forum: No registered users and 2 guests

cron