Dual VR 2.1 Installation Box

http://jbperf.com/dual_VR/index.html
Post Reply
rccardude04
Posts: 16
Joined: Tue Dec 29, 2020 7:07 pm

Dual VR 2.1 Installation Box

Post by rccardude04 » Tue Dec 29, 2020 7:18 pm

I'm new to the whole engine management thing so I probably don't have a ton of technical input/help for anyone here, but I did whip up a quick little box to install my Dual VR 2.1 board. I thought maybe this might help someone looking for a mounting solution.

I bought the internal version of the board and am using the +5 vref from my ms3 pnp to power the board and it's mounted just a few inches from the ECU in my passenger footwell.

Anyway, this is what I came up with. Feel free to do with it what you will! There may be a delay before all the files show. I just uploaded this to Thingiverse so it may take some time to process.

https://www.thingiverse.com/thing:4701967

Regards,
-Eric

jbelanger
Posts: 3860
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada
Contact:

Re: Dual VR 2.1 Installation Box

Post by jbelanger » Tue Dec 29, 2020 7:34 pm

Nice setup and thanks for sharing!

Jean
Image

rccardude04
Posts: 16
Joined: Tue Dec 29, 2020 7:07 pm

Re: Dual VR 2.1 Installation Box

Post by rccardude04 » Tue Dec 29, 2020 11:56 pm

jbelanger wrote:
Tue Dec 29, 2020 7:34 pm
Nice setup and thanks for sharing!

Jean
Very welcome! Hopefully it helps someone.

I did model this in inches, and most 3D printer slicers will expect millimeters, so it's pretty likely it'll need scaled to 2540% when importing into Cura/Simplify3D/etc.

Post Reply