Page 1 of 1

ms 2 -2.2board

PostPosted: Tue Dec 14, 2010 1:57 am
by ch940t
Hi JB, I 'm in the process of purchasing a ms 2 with a 2.2 board for a good deal. I'm doing the install on a 92 Volvo 940 turbo with Bosch 2.4. I know they are issues trying to use the vr (crank sensors) sensor on a 2.2 board, so one of the guys from the Turbobrick forum pointed me at your direction. I will have to purchase a Dual Vr board(2.2) in order for it to work on a ms 2.2 board. Also I'm planning on keeping the knock sensor. Also planning to go with 2 dual coil packs off a Toyota corolla( don't know if they have igniters) or possible a coilpack with no igniter and also sequential injection, please tell me what is needed and prices to USA. You do Paypal right?

Re: ms 2 -2.2board

PostPosted: Tue Dec 14, 2010 1:44 pm
by jbelanger
For sequential injection you will need to have a cam sensor. Also, before deciding on what type of drivers you need you have to see if you have low or high impedance injectors. You also have to find out if you need ignitors or not since that will have an impact on what type of circuits you need.

As for the knock sensor, I don't have anything for that but you'll still need some sort of controller. There has been a few thread on this on the msextra forum. The only ready-made solution I know of is the knocksense (http://www.viatrack.ca/).

Jean

Re: ms 2 -2.2board

PostPosted: Tue Dec 14, 2010 9:27 pm
by ch940t
Thanks JB