Firmware problems.

http://jbperf.com/quad_ign_inj/index.html

Firmware problems.

Postby Viroslash » Wed May 01, 2013 9:03 pm

Hello!
I have installed the 4-Channel Driver board only for sequential fuel firmware extra 3.2.4 in a VW 4 Cyl wasted spark 4 injectors. The problem is sequential does not works, still working in alternating mode. I install the firmware linked in jbperf and only 1 and 2 injectors works, another two are off.
I need a cam sensor only for sequential fuel?
Can you help me please?
Have a configurated msq for only sequential fuel y an 4 cyl and wasted spark?
Thank you.
Viroslash
 
Posts: 13
Joined: Wed Sep 26, 2012 7:57 am

Re: Firmware problems.

Postby jbelanger » Wed May 01, 2013 9:33 pm

Yes you need a cam sensor to run sequential injection. You also need to configure the settings correctly for sequential injection and additional injectors.

Since this is an MS2/Extra firmware issue, you should post this on the msextra forum. And post your msq there.

Jean
Image
jbelanger
 
Posts: 3627
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada


Return to 4-Channel Driver

Who is online

Users browsing this forum: No registered users and 1 guest

cron