Help - might have fried the I/O Extender

http://jbperf.com/io_extender/index.html
http://jbperf.com/io_extender/tinyIOx.html for the TinyIOx

Help - might have fried the I/O Extender

Postby hobieboy » Sat May 13, 2017 1:05 pm

I was testing with different set of coils (IGN-1A from DIYAutotune) with new harness that I made. As soon as I turn on MS3, I hear the coils sizzle then MS3 reports that it can no longer see the I/O Extender (device: EGT). I restarted everything, put back original coils/ignition system and the car starts & runs fine. But MS3 still does not see the I/O Extender.

I took the I/O Extender out & it didn't look to have any visible damages.

How could I determine if the board is dead?

thanks!
hobieboy
 
Posts: 60
Joined: Tue Mar 23, 2010 2:49 pm
Location: Up North

Re: Help - might have fried the I/O Extender

Postby hobieboy » Sat May 13, 2017 2:25 pm

oops... It the CAN-EGT+ board that I have not I/O Extender :oops:
hobieboy
 
Posts: 60
Joined: Tue Mar 23, 2010 2:49 pm
Location: Up North


Return to I/O Extender

Who is online

Users browsing this forum: No registered users and 3 guests

cron