CAN passthrough with Raspberry Pi

http://jbperf.com/io_extender/index.html
http://jbperf.com/io_extender/tinyIOx.html for the TinyIOx
MS2tester
Posts: 56
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: CAN passthrough with Raspberry Pi

Post by MS2tester » Sat Jan 11, 2020 3:35 pm

i was thinking a tinyIOx in the Pi zero pcb form with all the the 0 - 5 volt conditioning on the board for sensors be it zero to 5 volt linear sensors or NTC sensors ( pull up )
the second half as it is now but in a full pi board section form with a 12 volt converter on board and maybe preset holes for the VR boards so this can be modular
also easy to repair when broken
that would just leave the 2 timer output channels i don,t know if they need any further conditioning for outside the case?

MS2tester
Posts: 56
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: CAN passthrough with Raspberry Pi

Post by MS2tester » Sun Jan 12, 2020 11:08 am

_20200112_155108small.JPG
_20200112_155108small.JPG (217.19 KiB) Viewed 252 times
i think i might get an mini hdmi in there also :o

MS2tester
Posts: 56
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: CAN passthrough with Raspberry Pi

Post by MS2tester » Sun Jan 19, 2020 2:59 pm

adafruit_24_HAT_small_C.JPG
adafruit_24_HAT_small_C.JPG (258.59 KiB) Viewed 238 times
adafruit_24_HAT_small_C.JPG
adafruit_24_HAT_small_C.JPG (258.59 KiB) Viewed 238 times
well i got the screen working on a pi3b
Attachments
adafruit_24_hat_small_A.JPG
adafruit_24_hat_small_A.JPG (240.53 KiB) Viewed 238 times

MS2tester
Posts: 56
Joined: Mon Feb 23, 2015 8:04 am
Contact:

Re: CAN passthrough with Raspberry Pi

Post by MS2tester » Sat Jul 25, 2020 2:50 am

Is there any update for MS3 support?

jbelanger
Posts: 3827
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada
Contact:

Re: CAN passthrough with Raspberry Pi

Post by jbelanger » Tue Jul 28, 2020 1:27 am

There has not been any new version of the firmware since my last post. So the same constraints apply.

Jean
Image

Post Reply