ms 2 -2.2board

http://jbperf.com/dual_VR/index.html

ms 2 -2.2board

Postby ch940t » Tue Dec 14, 2010 1:57 am

Hi JB, I 'm in the process of purchasing a ms 2 with a 2.2 board for a good deal. I'm doing the install on a 92 Volvo 940 turbo with Bosch 2.4. I know they are issues trying to use the vr (crank sensors) sensor on a 2.2 board, so one of the guys from the Turbobrick forum pointed me at your direction. I will have to purchase a Dual Vr board(2.2) in order for it to work on a ms 2.2 board. Also I'm planning on keeping the knock sensor. Also planning to go with 2 dual coil packs off a Toyota corolla( don't know if they have igniters) or possible a coilpack with no igniter and also sequential injection, please tell me what is needed and prices to USA. You do Paypal right?
ch940t
 
Posts: 2
Joined: Tue Dec 14, 2010 1:19 am

Re: ms 2 -2.2board

Postby jbelanger » Tue Dec 14, 2010 1:44 pm

For sequential injection you will need to have a cam sensor. Also, before deciding on what type of drivers you need you have to see if you have low or high impedance injectors. You also have to find out if you need ignitors or not since that will have an impact on what type of circuits you need.

As for the knock sensor, I don't have anything for that but you'll still need some sort of controller. There has been a few thread on this on the msextra forum. The only ready-made solution I know of is the knocksense (http://www.viatrack.ca/).

Jean
Image
jbelanger
 
Posts: 3633
Joined: Sat Oct 03, 2009 12:24 pm
Location: Quebec, Canada

Re: ms 2 -2.2board

Postby ch940t » Tue Dec 14, 2010 9:27 pm

Thanks JB
ch940t
 
Posts: 2
Joined: Tue Dec 14, 2010 1:19 am


Return to Dual VR

Who is online

Users browsing this forum: No registered users and 0 guests

cron